« IPON: Switching by IP Addresses | Main | “3D Turtle Graphics” by using a 3D Printer »

3D-printing plates without “support”

Kanada, Y., I/O 2015-4 (in Japanese).

[ 日本語のページ ]

Abstract: When printing a plate (dish) using a 3D printer, normally, so-called “support” material, which is disposed after printing, is required to be printed and to support the plate. However, try to create thin plates without using such superfluous material! Some devices are required to print them, but it is not so difficult.

IO201504dish1.jpg IO201504dish2.jpg

This article was revised and published as an English paper: 3D-Printing Plates without “Support”

Introduction to this research theme: 3D shape formation technologies

Keywords:

Post a comment

1013-06-240.jpg

Objects printed by using the new direction-specified design and printing technology are sold in Dasyn Yahoo! Japan shop.

About

This page contains a single entry from the blog posted on March 21, 2015 6:51 PM.

Many more can be found on the main index page or by looking through the archives.

(C) Copyright 2007 by Yasusi Kanada
Powered by
Movable Type 3.36